Modules Y&Y M618 and Y&Y M668 are CE & SEMKO Marked, under reference number: 610596 Comply with EN61347-2-7 & EN61347-1, under test report number: JGZ0604136-1. EN60925, under test report number: JGZ0704320-1 All modules are suitable for Maintained and Non-Maintained Type. All modules are suitable for Electronic Ballast and Conventional Ballast. Operating voltage is 220-240V 50Hz +/- 6% single phase.

Application:
The modules incorporate 4 pole change over relays. Therefore, all modules are suitable for Electronic Ballast (High Frequency Ballast) and Conventional Ballast (Switch Start Control Gear).

• The circuit shall be suitable for use at 220V - 240V 50Hz +/- 6%.
  
• The module comprises battery charger, solid state automatic device operating a changeover relay, deep discharge protection circuit, LED charge indicator and NC test switch.
  
• The method of connection is by terminal block and a quick release mechanism is fitting so that leads may easily be removed. Wires of cross sectional area 0.5 - 2.0mm2 may be connected by pushing a solid conductor into the connection. We only use push connection terminals these not only give the benefit of fast installation but you cannot over tighten like you can with screw. This over tightening can cause the connection to break and some free on delivery to site and thus causing the product not to work.
  
• The red LED is normally continuously lit and this shows that a charge current is flowing the battery. The red LED goes out during the un-switched supply cut or the battery fails. A charge time of 24 hours should be allowed before testing the unit for its rated duration.
  
• Distance between module and luminaire should be kept to a minimum and must be within 1 metre for the to be self-contained (BSEN60598-2-22). The luminaire shall be provided with an integral NC test switch for simulating failure of the normal supply. Manually operated NC test switch shall be self-resetting.
  
• The unit is confirmed to provide minimum 3 hours emergency duration upon mains failure.
  
• The ambient temperature range for the module is 0-70°C but in any event the center side of can should not exceed 70°C
  
• The maximum operating temperature of battery packs is 70°C. This should not be exceeded, or the operational life of the cells will be reduced. (See our batteries figure for reference)
  
• A battery fuse is incorporated in the module to protect the battery from heavy discharge.
  
• Although the charger is already short circuit protected it may be desirable for isolation to include a fuse in the circuit.
  
• Linking device is possible to cover a larger selection of the lamps wiliest still optimizing the lamps performance by maintaining the battery discharge current from the battery in its ideal current range.
  
  

Connection Diagram:

Technical Data for M6 Series:

Ballast Lumen Factors for M6 Series:

* Link for 5 & 6 Terminals

Technical Data for M3 Series:

Ballast Lumen Factors for M3 Series:

* Link for 5 & 6 Terminals

Technical Data for M3 Series:

Ballast Lumen Factors for M3 Series:

* Link for 5 & 6 Terminals

Technical Data for M2 Series:

Ballast Lumen Factors for M2 Series:

* Link for 5 & 6 Terminals

Technical Data for M8 Series:

Ballast Lumen Factors for M8 Series:

* Link for 5 & 6 Terminals

Technical Data For M7 Series:

Ballast Lumen Factors for M7 Series:

* Link for 5 & 6 Terminals